Studio-technologies 55 2005 Manual do Utilizador descarregar pdf (Página 20)

Issue 5, August 2005 Model 55/56 User Guide

Page 20 Studio Technologies, Inc.

Operation

Now that you’ve installed and conﬁ gured

the system, you’re ready to go. You should

ﬁ nd operation very easy.

Model 55 Central Controller

The Model 55 front panel contains three

LEDs. The power present LED should

be lit whenever AC mains power is con-

nected. During normal operation the Over

Current LED will not be lit. It will ﬂ ash only

if there is a problem interfacing with the

Model 56 Control Console or the talent

ampliﬁ ers that you have connected. Refer

to the Troubleshooting section if the Over

Current LED lights.

The Input Data LED will light whenever

a message is received. Refer to the

Troubleshooting section if the LED does

not ﬂ ash in response to a message from

the Model 56 Control Console.

Model 56 Control Console

All StudioComm functions are controlled

using the Model 56 Control Console.

To make things easy, we’ve divided the

StudioComm functions into three main

groups: input-output selection, control

room output, and communications

functions.

Control Room/Meter Source Selection

To select an input for monitoring in the

control room, press one of the four CR

buttons. The corresponding LED in the

CR column will light to let you know which

input is selected. If the input is set for

mono the LED will continually ﬂ ash on

and off as a warning. The same source

will be connected to the meter output.

The system may have been conﬁ gured

to allow two control room sources to

be selected simultaneously. If so, select

the ﬁ rst source by pressing and holding

one of the four CR buttons. Then, while

keeping the ﬁ rst button pressed, select

the second source by pressing one of

the three other CR buttons. The two

sources will be added (summed or mixed)

together: L+L, R+R.

Headphone Source Selection

To select an input source for the head-

phone output, press and hold the Phones

button and press one of the four CR but-

tons. In the Phones column, the LED for

the input you select will light. If the input

is set for mono the LED will continually

ﬂ ash on and off as a warning.

A special function allows you to select no

input to be sent to the headphones. This

ensures a quiet feed to the phones, but

still allows the talk to phones function to

be used. To select no input, simply press

and hold the Phones button, then press

both Communications Level buttons at the

same time. The Level buttons are located

to the right of the two Communications but-

tons. All LEDs in the Phones column will

be off when no input is selected. To again

select one of the four inputs, press and

hold the Phones button, then press one

of the four CR buttons.

Dub Source Selection

To select an input source for the dub

out-put, press and hold the Dub button

and press one of the four CR buttons. The

appropriate LED in the Dub column will

light. If the input is set for mono the LED

will continually ﬂ ash on and off as a warn-

ing. You can select no input just as you

did for the headphones. Press and hold

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Comentários a estes Manuais

Sem comentários